HackRF One Acrylic Case
Software Defined Radio HackRF One SDR-Modul. HackRF One is an open source USB hardware platform. For Developer, Hacker and Pentester.
HackRF One, Software Defined Radio Acrylic Case
Acrylic Case for HackRF One. This is the official Case for HackRF One SDR PCB. Access all pins and connections from outside. Perfect for development und testing with your HackRF SDR.
Assembly Instructions Warning: Do not overtighten! Hand-tighten only at every step.
Use a guitar pick or spudger to extract the HackRF One circuit board from the black plastic case.
Insert one long screw into each corner of the bottom acrylic panel. Secure each long screw with a short (5 mm) spacer on the opposite side of the panel.
Place the HackRF One circuit board (facing up) on top of the bottom panel, fitting the ends of the long screws through the corner mounting holes of the circuit board.
Secure the circuit board with one long (6 mm) spacer in each corner.
Place the top acrylic panel on top of the circuit board, aligning the cutouts with the circuit board’s expansion headers. Secure each corner with a short screw.
Acrylic Case Only!
Check also the HackRF One Porta Pack modul.